TK Eagle Eye Sight Set Ruger Mark IV 22/45

Tandemkross Eagle Eye Sight Set for Ruger® Mark IV™ 22/45™





Approximate lower-third co-witness with TANDEMKROSS Shadow Mount V3
Bright fiber optics and a tall sight plane for fast target acquisition
Fully adjustable rear sight and quick-change front light pipe
The Eagle Eye Fiber Optic Sight Set for Ruger® Mark™ Series gives you a bright sight picture and a low co-witness with common red dots when used with the TANDEMKROSS Shadow Mount V3 or V2* (see compatibility notes below). Designed with speed and simplicity in mind, the sights raise your sight picture for faster acquisition while maintaining a sleek profile when paired with an optic or solo!

Whether you’re building a competition-ready rimfire pistol, tactical plinker, or something else entirely, rapid target acquisition matters. The bright fiber and tall sight plane let you find your target in any situation while giving you peace of mind in case your electronic optic fails.

TANDEMKROSS’s unique mounting solution for the rear sight installs quickly and securely. A dovetail insert and screw firmly fasten the rear sight to the receiver with no permanent modification required. This unique installation method smoothly blends the rear sight into the outside diameter of the receiver. Fiber colors are also user-changeable in seconds, allowing you to modify the sights to your personal preference.

Bright, simple to install, and made for the Mark™ Series: get your Eagle Eye Sight Set today.

Supported Models:
Ruger® Mark II™
Ruger® Mark III™ & 22/45™
Ruger® Mark IV™ & 22/45™ (LITE and bull barrel)
COMPATIBILITY NOTE:

NOT compatible with fixed sight models, tapered barrel models, models without factory iron sights, or models with “vent ribs”/direct optic mounts (such as Ruger® model number 43949)
*Cowitness not achievable with C-More Railway or C-More Slideride optic on Shadow Mount V2. An approximate lower-third cowitness achievable with all other compatible footprints on both V2 and V3 Shadow Mounts
IMPORTANT:

Gunsmith assistance strongly recommended for removing factory rear sight
Slight misalignment between the front sight mounting hole, optic mount holes, and rear sight dovetail typical on some receivers. Some of these elements may look slightly tilted relative to the others. Any possible misalignment will be emphasized with taller sights. The rear sight features unique rotational adjustment. This may not be enough to fully compensate for misalignment in worst case scenarios.